Lawn Mower
Briggs Stratton 85023 2.5-Gallon Gas Can Auto Shut-Off (CARB Compliant)
(Lawn Patio) Briggs and Stratton Power Products
Auto Shut-off
2.5 gallon capacity
3-way Grip, back handle for easy handling
Price:
$17.99
$7.46
Answers
I have this old lawn mower and I am looking to use the engine for a go kart. It is the "Snapper big six" 6HP engine for a walk-behind mower by briggs and stratton. I am looking for a site where I can go to get the basics down about this mower and hopefully read a diagram about all the parts not only of the engine but of the parts of the mower too. Can anyone find a page where I can learn this? Any other tips about making go-karts!? Thank you!
You can get all the information on the engine at outdoordistributors.com. Type in the model number and you will get an exploded view with part numbers.
HOW TO REPAIR the PULSA PRIME Carburetor on Lawnmowers with with Briggs amp; Stratton engines. Visit my channel for more repair videos; www ...
I have a new Craftsman mower with a Briggs and Sratton engine that doesn't start immediatly after turning it off. I'll mow for about 15 minutes stop to move something out of my way and it takes about 15 minutes until the lawn mower starts up again. Can someone help me?
the vent hole on the gas cap is plugged. clear it and the problem should be gone.
Price:
$249.00
$232.71
Non-CARB compliant/not for sale in California
7-Inch/11-inch wheel size
New loop handle
I have a briggs and stratton lawn mower. I've owned for about a year. It has never started easily, and now will not start at all. I am guessing that the carburetor needs to be cleaned. Can anyone provide instructions specifically for briggs and stratton lawn mowers (not sure of the model, bought it last year for about $140) regarding how to remove and clean the carburetor, and what the other causes may be?
Check and see if gas is in the carburetor bowl. If not the check valve is stuck a common problem with gunk build up. When you have it upside down it's under the float. Take the float off and get to it. The check valve is held with small wire parts so take your time and remember how it is held in place. You do have to put it back the same way you found it.
Before I did anything I would check for spark. Then I would pull the plug out and put two teaspoons of gas in the engine. Put the plug back and it will start and run most of the time. Only do that on a cold engine for your safety.
Price:
$12.99
$2.00
Replaces RJ19LM
Genuine Briggs Stratton Part
Fits Most BS L-Head Engines Including 475, 500, 600, 625, 650 675 Series
My lawn mower, "Weed Eater 21 B&S 550 series will not work. When i pull the starting cord, it begins to start, but dies as if the gas is not getting through or something. Yes, the lawn mower i have is a gas engine one.
how old is the gas? it could be bad. try draining the tank and putting in some fresh gas.On top of engine there should be big flat head screw. take that out and remove air filter and voila' there is your carb
Lawn mower cord wont go back in its in the spring what do i do?
If it keeps releasing, either you are winding the spring backwards or the spring itself is broken. Also if it has a starter clutch the steel balls may be dirty and causing the spring to unwind upon starting. The best method is to take the starter apart, clean the spring and starter housing. Hook the spring thru the starter housing into the cord reel, wind the spring using a 7/8" square board or tube that fits into the starter opening. Wind the spring until the small end of the spring drops into the slot in the starter housing, then insert your cord, tie a knot and release the starter slowly pulling in the cord. once the cord is pulled all the way in, pull it slightly out and slip the cord thru the handle and tie it in a knot. If you hear a squeal or high pitch noise replace the starter clutch.
Buy Cheap
- Briggs Stratton 491588S Flat Air Filter Cartridge
Price:
$13.99$2.99Individually packaged part
Use on 3.5-6.5 HP Quantum engines, 625-1575 series
Briggs Stratton 491588S
- Weed Eater WE-ONE 26-Inch 190cc Briggs Stratton 875 Series Gas Powered Riding Lawn Mower With Electric Start
Price:
$888.10$799.99190cc 26-Inch Deck
3 Forward and 1 Reverse Speed
Electric Start (no re-coil); 3-Inch Blade Adjustment
- Briggs Stratton 698369 Air Filter Foam Element
Price:
$13.99$4.05Use with 450-600 Series engines with plastic air cleaner housings
Individually packaged part
For 3.5-4.5 HP, Q 45, Classic, Sprint, and Quattro engines
4.5 briggs lawnmower runs too slow to mow - Tech Support Forum
Welcome
to Tech Support Forum home to more then 136,000 problems solved. Issues
have included: Spyware, Malware, Virus Issues, Windows, Microsoft,
Linux, Networking, Security, Hardware, and Gaming Getting your
problem solved is as easy as:
1. Registering for
a free account
2. Asking your
question
3. Receiving an answer
Registered members:
* Get free support
* Communicate privately with other members (PM).
i have a 4.5 briggs lawnmower not all that old and hardly used much it wont speed up enough to mow with its one of those throttle free types i,ve put a new sparkplug in put a new diapham on the carb and even swapped out the gastank and carb for another of the same type and still the same thing it will run but not speed up if you try to mow it will die because its running too slow i,ve worked on briggs motors for years but have never seen anything like this i cant think of anything else it could be any ideas
A push mower for the small and weak - Briggs amp; Stratton Quattro ...
When I lived on a military post, they had strict regulations about lawn mowing. My husband is a strapping lad, but he couldn't always mow the lawn right when it needed to be done, and it's expensive to pay someone else to do it! We didn't have our own mower, so I borrowed one all the time. I'm a little person at 5 feet 2 inches tall, and I do not have a lot of upper body strength. The mowers I was borrowing were SO heavy and hard to push! Not only that, when you pulled the string to start them, it had to be pulled WAY out, and my arms weren't long enough to do it in one fluid motion. That was the worst part. Sometimes it would take 10-15 minutes to start the thing because I had to pull the string and jump backwards at the same time to be able to pull the string long enough. It's a real skill.
...