Cyber Lawnmower .com

Where can i get an online manual for my troy bilt riding lawn mower?

Go to this link and input your model and serial #


http://manuals.mtdproducts.com/mtd/publi c/list.jsp?BrandCode=10001

2007-06-09 09:40:46 by kevin w

Troy-Bilt demonstrates why their push lawn mowers are even more effective with the unique Tri-Action Cutting System. Cut grass more effectively ...

It has a Briggs & Stratton 120000 model series motor

Remove square plug under the deck. Be sure to disconnect the spark-plug wire so the thing don't start if you have to move the blade.

2008-04-30 13:53:42 by lynn7hamilton

Price: $299.95 $269.89

3-in-1 cutting system--mulch, rear bag, and side discharge
12-inch rear wheels increase maneuverability over a variety of terrain
7021P is compliant for the state of California

it has new sparkplugs and all the obvious things. it was an automatic choke, but it broke and was too expensive to buy parts for, so they put in a manual choke. i put it on choke to turn on, then pull it away from choke as i am supposed to after it starts. after 3 or 4 days it stops working. i hear a put-put sound coming out of it when i try to start and a little greyish smoke. carb. was just cleaned.

Dabs sweety clean the plug and get some fresh gas in the mower. Pull out the choke and when it hits push in the chock half way, when it boggs push the choke all the way in.when the motor gets up to snuff warmth wize then the air/gas mix will not need to be as rich, by pushing in the choke you open up the throat of the carb and allow for more air to mix with the gas vapor.

2007-09-11 18:09:30 by dabo

Price: $15.99 $6.00

Blade width 2.25-inch
Blade length (measured diagonally): 20.9-inch
Blade center hole diameter 0.710 x 0.930 Outer hole:0.32-inch

My troy bilt lawn mower is only a year and two months old and before it would start and then struggle to stay running and then give out and die. The next day i tryed and it wont even start. I've drained the oil and put new troy bilt motor oil in. Second ive bought new gas and drained the old and put in the new... ive also tryed to strain it through buy not pulling donw the lever and it a push mower by the way. Third i've cleand the air filter. i dont know what else to do it just wont even start anymore..... i was thinking maybe new spark plug but i dont want to buy one and that not be it and its inly a year old and its stored in the shed it should be fine.

the spark plug is only a couple of bucks if moneys tight at least take it out and clean it. it should help.

2009-07-12 20:00:57 by JB

i have all new belts

If the pulley is attached with a bolt or nut, replace it right away. That includes any flat or lock washers. If you don't see any kind of washers, then they were lost the first time you lost pulley.
And spend a few extra bucks on a small tube of RED Loctite, red is the "permanent" version.
Check for worn spots and "wallowing" that will cause a chronic problem where the pulley is supposed to stay.

2007-07-18 18:58:46 by brez78